Configuring Burner Settings
The Burner settings tab displays before burning most of the disc types. On this tab, configure the settings as follows:
- Burner: displays the burner that CyberLink Power2Go will use to burn the disc.
- Write speed: select a write speed from the drop-down list. The speeds that are available is dependent on the drive installed in your computer.
- Number of copies: enter the number of copies of the disc you want to burn.
- Enable buffer underrun protection: select this option to ensure that data is written to disc without interruption. (An interruption in data can result in an unusable disc.)
- Write simulation before burning: select this option to perform a write simulation first to verify that your burner can burn to the disc at the selected speed without encountering any errors.
 |
Note: if you have enabled buffer underrun protection or have previously burned discs using the current settings, you do not need to run a simulation. |
- Close disc: select this option to write-protect a disc. Once burned, no further data can be added to the disc. If you do not select this option, you can create a multisession disc. See Multisession Discs for more information.
- Verify recorded data: select this option if you want CyberLink Power2Go to verify that the content was successfully burned to the disc. Select Quick verification to have CyberLink Power2Go quickly verify the correctness of the data, or Complete verification to check all of the data individually. The latter requires more time to complete the verification.
- Enable defect management: select this option to have CyberLink Power2Go try to fix any defects on a disc so that content burns correctly.