Power2Go

Copying Discs

With CyberLink Power2Go you can copy and burn the entire contents of a disc onto another disc. You can perform this function in both Power2Go Mode and using the Desktop Burning Gadget. Only the first step for opening the Copy Disc window is slightly different.

To copy a disc, do this:

1. Open the Copy Disc window by:
   • selecting the Copy Disc option, and then Copy Disc in the new task window when in Power2Go mode.
   • selecting the button on the Desktop Burning Gadget until the Copy Disc gadget displays, and then clicking on to open the Copy Disc window.
2. Select your source and target drives using the From and To drop-downs.
3. Select a Read speed and Write speed for each disc. The speeds you should select will depend on the burning drives you are using and the quality of the discs.
4. Select Ignore reading error if you want CyberLink Power2Go to copy the disc even if errors are encountered.
5. Select the Copy to hard disk option, if available, to also save a copy of the disc to your computer’s hard drive.
6. Select Copy whole disc if you want to copy the entire contents of the disc onto the destination disc.
7. Enter the Number of copies you want to burn.
8. If available, you can use the following options to assist with the burning process:
   • select Perform write simulation if you want CyberLink Power2Go to simulate the burning process first to ensure the burn will complete.
   • if available, select Verify recorded data if you want CyberLink Power2Go to verify that the content was successfully burned to the disc.
   • if available, select Enable defect management to have CyberLink Power2Go try to fix any defects on a disc so that content burns correctly.
9. Click Copy to begin the copy and burn process.
10. When burning is complete, select an option in the window that opens:
    • Click View Log to view the burning log. The log opens in your default TXT editor, where you can view and save it.
    • Click OK to close the window and then exit.

Copying Discs